Part 2 of : 32-bit shift register module using ESP-12F IOT module

Important : In the ESP-12F IOT module, jumper should be placed across 5V and COM as encircled in the following image. Otherwise, high voltage may destroy your 32-bit shift register module.

In the previous blog, we saw the circuit for programming ESP-12F IOT module.

Product links

CP2102 USB 2.0 to TTL UART SERIAL CONVERTER : https://robu.in/product/cp-2102-6-pin/

ESP-12F IOT Module : 

Read More
Part 1 of : ESP-12F IOT Module Programmer circuit

Circuit is done as shown in the diagram.

Product links

CP2102 USB 2.0 to TTL UART SERIAL CONVERTER : https://robu.in/product/cp-2102-6-pin/

ESP-12F IOT Module : http://www.haberocean.com/product/iot-module-using-esp-12f/

Connect “CP2102 USB 2.0 to TTL UART serial converter” to your PC and turn on the DC power source. Open Arduino IDE. Open the Blink program from the Examples.

Read More
Part 3 of 3 : 7-Digit seven segment display  module from Arduino UNO through 32-bit shift register module

7-digit seven segment display module can be controlled from three digital pins of Arduino UNO through shift register module. Circuit is done as shown in the image. Seven segment display module and shift register module should be powered from an external power supply.

Purchase 7-digit seven segment display module from http://www.haberocean.com/product/7-digit-seven-segment-display-module-with-negative-symbol/

Purchase shift register module from http://www.haberocean.com/product/shift-register-module-using-74hc595/

Upload the following program to your Arduino UNO.

Read More
Part 2 of 3 : Cascading two 32-bit shift register modules using Arduino UNO

While cascading the shift register modules, power should be given from an external power supply. Excess current from Arduino UNO may damage your Arduino UNO. Similarly, you can cascade more modules.

Purchase the module from http://www.haberocean.com/product/shift-register-module-using-74hc595/

Upload the following program to Arduino UNO. Change the value in customDelay() function to change the speed of running LED.

/* Shift Register Example Turning on the outputs of a 74HC595 using an array Hardware: * 74HC595 shift register * LEDs attached to each of the outputs of the shift register */ //Pin connected to ST_CP (12) of 74HC595 int latchPin = 12;
Read More
Part 1 of 3 : Interfacing 32-bit serial-in parallel-out Shift register module to Arduino UNO

Here, we will see the circuit to interface a 32-bit serial-in parallel-out Shift register module using Arduino UNO. Shift register module is powered from Arduino UNO.

This module will help to create 32 digital outputs from only 3 digital pins of Arduino. Purchase the module from http://www.amazon.in/dp/B07SZ2194H?ref=myi_title_dp. This module can be used in applications where more digital outputs are required such as LED cube, LED matrix etc.

Upload the following program to Arduino UNO.

Read More
X